橋架母線槽如何使用

How to use bridge bus duct

1、必須驗證母線槽干線相序正確，母線槽絕緣電阻不低于20MΩ

1. It must be verified that the phase sequence of busbar trunking is correct, and the insulation resistance of busbar trunking is not less than 20m Ω

2、保證母線槽干線不受液體、固體的侵入

2. Ensure that the main line of bus duct is not invaded by liquid and solid

3、必須確認安裝支架穩固，連接螺栓可靠的連接

3. It must be confirmed that the mounting bracket is stable and the connecting bolts are reliably connected

4、接觸帶電設備的零部件有危險！

4. Danger in contact with parts of live equipment!

5、橋架母線槽如何使用母線槽開始送電時，不得帶負載

5. How to use the bus duct of the bridge to start power transmission, do not carry load

6、檢查總的負載電流不超過主母線電流或設計電流。

6. Check that the total load current does not exceed the main bus current or design current.

橋架母線槽四大優勢

Four advantages of bridge bus duct

鋁型材外殼經過陽極氧化10u后鍍鋅防腐性能要好得多，比鋼制外殼對不同牌號鋁合金板材與鍍鋅銅板的長期大氣暴露試驗表明其腐蝕深度前者大約是后者的二十分之一。

After 10u anodizing, the corrosion resistance of aluminum profile shell is much better than that of steel shell. The long-term atmospheric exposure test of aluminum alloy plate and galvanized copper plate shows that the corrosion depth of the former is about one twentieth of that of the latter.

導電排上有絕緣層，相與相間還有一定的空氣間隙，導電排與外殼間還有DMC材料壓制的絕緣墊塊，三重絕緣，保證母線槽的絕緣萬無一失，尤其在潮濕的環境下使用更顯其優越性。

There is an insulating layer on the conductive bar, and there is a certain air gap between the phases. There is an insulating cushion block pressed by DMC material between the conductive bar and the shell, which is triple insulated to ensure the insulation of the bus duct, especially in the humid environment.

直線型母線槽的長度除受運輸能力限制外，其設計和生產能力不受長度限制，能滿足工程尤其是現代廠房對大跨度母線槽的需求。由于其剛度好，6m跨度之間可以不安裝吊架。

The length of linear bus duct is not limited by the length except by the transportation capacity, and its design and production capacity are not limited by the length, which can meet the needs of large-span bus duct in engineering, especially in modern plants. Due to its good rigidity, no hanger can be installed between 6m spans.

由于全長外型尺寸一致，內部結構對稱，在任一側都可以排列為L1,L2,L3，N，因此倒相很容易，安裝方便。

Since the overall dimensions of the whole length are consistent, and the internal structure is symmetrical, it can be arranged as L1, L2, L3 and N on either side, so the phase inversion is very easy and the installation is convenient.

橋架母線槽如何維修

How to repair the bridge bus duct

1、必須切斷母線槽電源，才能進行維護保養工作

1. The power supply of bus duct must be cut off before maintenance

2、使用三個月后須停電檢查連接螺栓緊固情況，每年進行檢查

2. After three months of use, the power must be cut off to check the fastening of connecting bolts, and a comprehensive inspection shall be conducted every year

3、出現異常情況請立即斷電檢查，確定情況后再作處理

3. In case of any abnormal condition, please cut off the power immediately for inspection, and handle it after confirming the condition

4、必須影響母線槽正常運行的不利因素，如滴水、導電粉塵、熱源等

4. The adverse factors affecting the normal operation of the bus duct must be eliminated, such as dripping water, conductive dust, heat source, etc

橋架母線槽儲存需要注意些什么

What should be paid attention to for storage of bridge bus duct

1、防止灰塵、液體侵入，并遠離通道

1. Prevent dust and liquid intrusion and keep away from the passage

2、不要儲存在室外，避免陽光曝曬

2. Do not store outdoors, avoid sun exposure

3、濟南橋架母線槽如何使用母線槽堆放應在等高的木塊隔開，建議不超過5層

3. How to use the bus duct of the bridge? The bus duct shall be stacked in equal height wooden blocks. It is recommended that it should not exceed 5 layers

4、安裝前不要將包裝物全部拆除。

4. Do not remove all packages before installation.

橋架母線槽使用優勢和維修的事項就講解到這里了，您可以關注我們的網站m.ymmgjx.net咨詢了解更多事項。

Here are the advantages and maintenance of the bridge bus duct. You can follow our website www.sddlqj Cn for more information.