在很多時候選擇橋架使用比較多的還是槽式橋架，因此在進行選擇的時候一定要非常的注意，選用要點都有什么呢？下面小編整理了十點要求大家參考一下。

In many cases, the tray used more is the trough tray, so you must pay great attention to the selection. What are the key points of selection? Here are ten points for your reference.

1）槽式電纜橋架及其支吊架在腐蝕環境中使用，應采用耐腐蝕材料或防腐處理。防腐處理方法應符合要求。

1) The trough type cable tray and its supports and hangers shall be made of corrosion-resistant materials or treated with corrosion protection when used in corrosive environment. The anti-corrosion treatment method shall meet the environmental protection requirements.

2）在有防火要求的區段，電纜橋架可在電纜梯和橋架內加裝耐火或阻燃板、網等材料，形成封閉或半封閉結構，并采取以下措施：防火層可用于形成封閉或半封閉結構。耐火性應符合有關規定。

2) In sections with fire protection requirements, fire-resistant or flame-retardant plates, nets and other materials can be added to the cable ladder and cable tray to form a closed or semi closed structure, and the following measures can be taken: the fire-proof layer can be used to form a closed or semi closed structure. Fire resistance shall comply with relevant regulations.

3）在防火要求高的地方，不宜使用藍薄荷金橋。

3) BLUE MINT golden bridge should not be used in places with high fire prevention requirements.

4）槽式電纜橋架的寬度和高度的選擇應滿足填充率要求。一般情況下，電纜梯和橋架中的填充率，電力電纜應為40%～50%，控制電纜應為50%～70%。，并應預留10%25%的項目開發津貼。

4) The width and height of trough cable tray shall meet the requirements of filling rate. Generally, the filling rate in cable ladder and bridge shall be 40% - 50% for power cable and 50% - 70% for control cable., And 10% to 25% of the project development allowance should be reserved.

5)選擇電纜橋架載荷等級時，電纜橋架的工作均布載荷不應大于所選電纜橋架載荷等級的額定均布載荷。如果電纜橋架支吊架的實際跨度不等于2m，分布荷載應符合要求。

5) When selecting the load grade of cable tray, the working uniform load of cable tray shall not be greater than the rated uniform load of the selected load grade of cable tray. If the actual span of cable tray supports and hangers is not equal to 2m, the distributed load shall meet the requirements.

6）在各種構件和支吊架滿足相應載荷的情況下，其規格和尺寸應與托盤和梯架的直段和彎曲系列相匹配。

6) Under the condition that various components and supports and hangers meet the corresponding loads, their specifications and dimensions should match the straight section and bending series of trays and ladders.

7)選擇槽式電纜橋架的直通或引出引下裝置時，不應小于電纜橋架內電纜的允許彎曲半徑。

7) When selecting the straight through or leading out and leading down device of the trough cable tray, it should not be less than the allowable bending radius of the cable in the cable tray.

8)跨度大于6m的鋼制電纜橋架和跨度大于2m或承載要求大于D級的鋁合金電纜橋架，應根據工程條件計算或驗證其強度、剛度和穩定性。

8) The strength, stiffness and stability of steel cable trays with a span greater than 6m and aluminum alloy cable trays with a span greater than 2m or a bearing requirement greater than grade D shall be calculated or verified according to the engineering conditions.

9)當多組電纜橋架平行敷設在同一高度時，應考慮相鄰電纜橋架之間的維護和檢查距離。

9) When multiple groups of cable trays are laid in parallel at the same height, the maintenance and inspection distance between adjacent cable trays should be considered.

10)濟南電纜橋架廠家認為槽式電纜橋架直通單件的標準長度可以是2、3、4、6m。

10) Jinan cable tray manufacturer believes that the standard length of straight through single piece of trough cable tray can be 2, 3, 4, 6m.

以上就是今天為大家介紹的關于問題以及注意事項的全部?jī)?nèi)容，希望對大家能有所幫助，想要了解更多內容可以電話聯系我們或者關注我們的網站http://m.ymmgjx.net，我們的工作人員會及時與您取得聯系。

The above is all about the problems and precautions introduced to you today. I hope it can help you. If you want to know more, you can contact us by phone or follow our website http://m.ymmgjx.net , our staff will contact you in time.