Galvanizing cable tray is to use electrolytic equipment to degrease and pickle cable tray and put it into a solution containing zinc salt, connect the negative of electrolytic equipment, place a zinc plate on the opposite side of cable tray, connect the positive power supply of electrolytic equipment, and deposit a layer of zinc on cable tray by using the current to move from positive to negative direction. cable tray plating is processed first and then galvanized, which has the effect of anti-corrosion.

關于鍍鋅電纜橋架具有很多的知識：

There is a lot of knowledge about galvanized cable tray:

鍍鋅電纜橋架具有的四點優異性能

Four excellent environmental protection properties of galvanized cable tray

1、成分內不含Ph、cr、Hg等重金屬；

1. The ingredients do not contain heavy metals such as Ph, Cr, Hg, etc;

2、歸屬于厚膜型材料，觸變性能好，經充分?jǐn)嚢韬螅偌踊虿患酉♂寗纯赏垦b施工。由于鍍鋅固體分含量高達77％，固線器，一次無氣噴涂可獲得較高的膜厚，減少了有機溶劑的揮發量，降低干燥能耗，這些均有利于環境保護。

2. It belongs to thick film material with good thixotropic property. After full mixing, with little or no diluent, coating can be carried out. Due to the high solid content of 77% in zinc plating, a higher film thickness can be obtained through a fixed wire device and a single airless spraying, reducing the volatilization of organic solvents and drying energy consumption, all of which are beneficial for environmental protection.

3、經過測試證明：絕大多數鍍鋅的溶劑和稀釋劑內不含甲苯、酮類、鹵代烴等毒性大的有機溶劑。

3. The test shows that most of the solvents and diluents for zinc plating do not contain toluene, ketones, haloalkane and other toxic organic solvents.

4、鍍鋅電纜橋架是替代熱浸鍍鋅、電弧(熱)噴鋅的好材料，對減少三廢、降低能耗，提高環境保護的社會效益的作用就更加明顯。

4. Galvanized cable tray is a good material to replace hot-dip galvanizing and arc (hot) zinc spraying, and it plays a more obvious role in reducing the three wastes, reducing energy consumption, and improving the social benefits of environmental protection.

鍍鋅電纜橋架設備的三點自我檢修事項

Three points of self maintenance for galvanized cable tray equipment

1 、電纜橋架設備平衡氣缸動作狀況及其機油潤滑系統油路,接頭等測試檢查.

1. Test and check the action of balance cylinder of cable tray equipment and the oil circuit and connector of oil lubrication system

2 、電纜橋架設備滑塊與導軌之間的摩擦較為頻繁，應做必要的調整較正，檢查接頭部位的潤滑及管路等，保證良好的運轉。

2. The friction between the sliding block of cable tray equipment and the guide rail is frequent, so it is necessary to make necessary adjustment and alignment, check the lubrication quality of the joints and pipelines, etc., to ensure good operation.

3 、定期為電纜橋架設備齒輪部位潤滑：齒輪傳動箱及內部機件因?yàn)榻?jīng)常運轉損壞的可能性比較大，出現松動的可能性更大。當這些部位出現噪音后，可先對此進行潤滑，然后根據振動情況，檢查系統之間的的注油點的吐油量和壓力測試，進行適當?shù)恼{(diào)整。

3. Regularly lubricate the gear parts of cable tray equipment: the gear box and internal parts are more likely to be damaged due to frequent operation, so they are more likely to become loose. When noise occurs in these areas, lubrication can be carried out first, and then, based on the vibration situation, the oil discharge volume and pressure test of the oil injection points between the systems can be checked, and appropriate adjustments can be made.